dpCREATOR FluidNC 4.1.1 firmware for R2/R3 controllers (Ethernet + WebUI)

FluidNC 4.1.1 with W5500 wired Ethernet for the dpCREATOR R2 and R3 controllers. Free for registered customers.

This build adds job recovery after a stop, live Z adjust while a job runs, the SD card as a network drive and a login for the board. The full dpCREATOR WebUI is free with the R3. All about the firmware.

• Board: dpCREATOR R2/R3 (ESP32-S3)
• Ethernet: W5500, a wired TCP/IP connection to your PC instead of Wi-Fi
• How to install: log in, open the Flash Firmware page in Chrome or Edge, connect the board with a USB cable and press Install. Nothing to download or install on your PC.
• Earlier release: the FluidNC 4.0.3 ZIP stays available in My Account → Downloads.
• Setup guide: Ethernet (W5500) setup