Short videos of the SmartTabUI pendant, one topic at a time, from installing it to recovering a job.

SmartTabUI in one minute

The handheld pendant for FluidNC: jog, home, probe and run jobs from the SD card, next to the WebUI. (0:55)

Installing the pendant

One GX12 cable, a few lines in the controller's config, and the firmware from dpcreator.eu. (1:27)

Pendant settings

Theme, machine type, the P6 button, DRO axes, brightness and volume, kept on the pendant itself. (1:21)

The screen and jogging

The DRO, jogging with the handwheel and step, and the feed, rapid and spindle overrides. (1:07)

Homing and probing

The Home tab: home all or one axis, work offsets G54 to G59, zero, and the probing cycles. (1:17)

Files, Prepare and Run

Pick a job on the SD card, view its toolpath, prepare and start it. (1:17)

During a job

Z adjust while cutting, Hold, Rewind and Abort. (1:18)

Job recovery

Carry on after a power cut, an E-stop or an alarm, from the line you choose. (1:15)

Measure and Record

Double-tap ENABLE: measure a part from its corners, or record waypoints, with the WebUI. (1:26)

Macros, Term and the WebUI

Run macros and commands from the pendant, and how it works together with the WebUI. (1:19)

See also the WebUI video tutorials and the Studio video tutorials.